µ-Dimension 180-00108 uPrint User Manual page 32

Setup
Press Load selected
4. After the selected material bays have been loaded to the head, the display will show Preparing and
the inactive model material bay, for example, Preparing M2. This will repeat for the inactive support
material bay. An asterisk will be placed next to the model and support material bays that are active.
5. When the material has been loaded to the head and the secondary material bays have been prepared,
press Done... the display will show Wait for Part or Ready to Build (if a part is in the queue) and will
also show the amount of material remaining in both material bays.
Document Number 206465-0001
Figure 27: Load selected
It can take up to 5 minutes for the printer to load the material
to the head.
Figure 28: Press done when finished loading
Press Done...
Note:
32
User Guide