Emptying The Purge Bucket; Replacing Material For Single Material Bay - µ-Dimension 180-00108 uPrint User Manual

Operation

Emptying the purge bucket

Empty the purge bucket after each build to avoid part quality issues or damage to the printer.
1. With a gloved hand, lift up on the purge bucket and pull it off of the two mounts. See
2. Empty the purge bucket.
3. Place the purge bucket over the two mounts and push down to lock in place.
When reinstalling the purge bucket, make sure that it locks on both mounts

Replacing material for single material bay

1. From the display panel press Material... The display will show Add/Remove and S1(remaining%)
and M1(remaining%). Asterisks will mark the currently active material bays (the material bays that are
currently loaded to the head).
2. Press Unload...
3. Select Unload both, Unload Model or Unload Support.
4. The printer will now unload material from the head. When the material has unloaded, you will need to
replace the material carriers.
5. Place the carrier on a flat stable surface.
Document Number 206465-0001
Wear gloves when emptying the purge bucket.
Figure 33: Emptying the purge bucket
Purge bucket mounts
Purge bucket
and hangs flush with the chamber wall to avoid damage.
WARNING
CAUTION
43
Figure 33
User Guide