The Display Panel During Build; Chamber Lights - µ-Dimension 180-00108 uPrint User Manual

Operation

The display panel during build

The top two lines of the display panel will show the printer status. See
display panel will show the amount of model and support material that remains in the carriers.
Printer status
Model file name
Support material
remaining
Printer status
Model file name
Support material
remaining in bay 1
Support material
remaining in bay 2

Chamber Lights

When a part starts to build, the chamber lights are automatically ON. The default time-out for the lights is
30 minutes. You can toggle the lights ON or OFF through the display panel.
You can set the chamber lights on permanently, however the chamber lights will return to factory settings
when power is cycled.
1. From Idle or Ready to Build, on the display panel press Maintenance.
2. Press Setup.
3. Press Lights Always On.
Repeat this process to turn this option off.
Document Number 206465-0001
Figure 32: Display panel during build
Single material bay
If a material amount is flashing, it indicates that the
remaining material will not be enough to complete the
current build.
Dual material bay
Note:
Figure 32. The bottom line of the
Model material
remaining
Model material remaining
in bay1
Model material remaining
in bay2
40
User Guide