Loading Material To The Head For The Single Material Bay; Adding Material Carriers To The Dual Material Bays - µ-Dimension 180-00108 uPrint User Manual

Setup

Loading material to the head for the single material bay

1. Once the material carriers have been added to the material bays, press Load... next, press Load
Both. The display will show Loading Model. After the model material has loaded to the head the
display will show Loading Support.
Press Material Load...
2. When the printer has finished loading support material to the head, press Done... the display will show
Wait for Part or Ready to Build (if a part is in the queue) and will also show the amount of material
remaining on the model and support spools.

Adding material carriers to the dual material bays

Once material spools have been inserted into the carriers, you will need to add the carrier into the material
bay.
An instructional video can be viewed at
1. From the display panel press Material, the display will show Add/Remove.
Document Number 206465-0001
Figure 24: Loading material to the head
It can take up to 5 minutes for the printer to load the material
to the head.
http://www.uPrintDimension.com/productinformation/customerinfo
Press Load Both
Note:
30
User Guide