Liquefier Tip Replacement - µ-Dimension SST 1200es User Manual

Liquefier Tip Replacement

Replace Tips at approximately 2000 hours - depending upon
operating conditions. Tips can also be damaged by improper care
while performing maintenance in the area around the tips.
Inspect the heat shield Teflon shield for wear or damage each time
the liquefier tips are replaced.
CatalystEX displays the tip time (hrs) - from the Printer Services Tab -
Printer Info button (Tip time will reset to zero after replacement).
Removing Tips
1. Enter Tip Maintenance - Replace Tips.
• From Idle, Select Maintenance > Machine > Tip >
then Replace.
• The printer will display Load Model - Unloading,
followed by Tip Maintenance - Adjusting
Temperature.
• After the temperature has stabilized, the printer will display
Tip Maintenance - Replace Tips. You can now
open the printer door and replace the tips - or you can
Cancel the tip replacement procedure.
2. Remove Plastic Head Cover
• Remove plastic head cover by squeezing raised pads on
sides of cover.
Squeeze Tabs
(one on each side)
to Remove Cover.
3. Remove Tips
(Figure 19 on page
NOTE
Figure 18: Removing the Head Cover
50)
Dimension BST 1200es / SST 1200es User Guide
Maintenance 49