Clean Fan Filter; Replace The Tip Wipe Assembly - µ-Dimension BST 1200es User Manual

Clean fan filter

To clean the fan filter:
1. Locate the lower fan on the rear panel of the printer and remove the plastic frame (snaps on
and off) that secures the fan filter. See
Figure 25: Lower fan location
2. Clean the filter with soap and water, and blot it dry.
3. Reassemble.

Replace the tip wipe assembly

Note:
performing Tip Cleaning Assembly Maintenance.
1. Completely power down the printer. See
2. Move the Toggle Head to the left of the machine in order to gain access to the tip wipe
assembly, see
The tip wipe assembly should be replaced after 500 hours, prior to
Figure 25
Figure 25
"Powering Off" on page 33.
38