Table of Contents
Advertisement
Resuming Build from Pause Mode
If you have pressed Pause, and are ready to resume building the part, press Resume. The printer
resumes modeling.
Resuming Operations from Standby Mode
After several minutes of inactivity, the printer enters Standby mode. During Standby, the head
temperature will decrease to save energy.
Continue operation from Standby mode:
1.
Press Resume.
•
The panel displays Ready to Build and your part's name (if there is a part in the queue).
It also shows the amount of material remaining in the model material cartridge and the
support material cartridge
(e.g. *Model 90%, *Support 85%).
•
Start Model begins blinking.
2.
Press Start Model to begin modeling.
(The printer may require a few minutes to warm up to proper build temperatures. You can view
the temperature values in the display.)
Canceling a Job
You can cancel a job at any time while the part is building.
Cancel a job:
1.
Press Pause.
2.
Once the printer stops building, press Cancel Build.
The panel displays Are you Sure?
3.
Press Yes. The panel displays Build Stopped followed by the part name.
4.
The panel prompts you to remove the part and replace the modeling base.
Modeling Base" on page 26.
panel asks: Part Removed?
5.
Press Yes only after removing the part - refer to
CAUTION:
and a service call will be required.
Auto power down
You can set the printer to automatically power down when a build is complete. This option will save
energy usage.
1.
While the printer is building, press the Auto Power Down button.
2.
Turn the power switch, located on the left side of the printer, to the OFF position.
Once the chamber door has been opened and closed, the
If you press
before removing the part, the system can be damaged,
Yes
32
"Removing a Completed Part" on page
See "Inserting a
33".
Hide quick links:
Advertisement
Table of Contents
