Snmp Specifications; Snmp Defaults - Alcatel-Lucent OmniSwitch 6450 Management Manual

SNMP Specifications

SNMP Specifications
The following table lists specifications for the SNMP protocol.
RFCs Supported for SNMPv2
RFCs Supported for SNMPv3
Platforms Supported
SNMPv1, SNMPv2, SNMPv3
SNMPv1 and SNMPv2
Authentication
SNMPv1, SNMPv2 Encryption
SNMPv1 and SNMPv2 Security
requests accepted by the switch
SNMPv3 Authentication
SNMPv3 Encryption
SNMPv3 Security requests
accepted by the switch.
SNMP traps
Maximum number of SNMP
sessions that can be established
on an OmniSwitch.

SNMP Defaults

The following table describes the default values of the SNMP protocol parameters.
Parameter Description
SNMP Management Station
Community Strings
SNMP Security setting
Trap filtering
Trap Absorption
page 3-2
1902 through 1907 - SNMPv2c Management Framework
1908 - Coexistence and transitions relating to SNMPv1 and SNMPv2c
2570 – Version 3 of the Internet Standard Network Management
Framework
2571 – Architecture for Describing SNMP Management Frameworks
2572 – Message Processing and Dispatching for SNMP
2573 – SNMPv3 Applications
2574 – User-based Security Model (USM) for version 3 SNMP
2575 – View-based Access Control Model (VACM) for SNMP
2576 – Coexistence between SNMP versions
OmniSwitch 6250, 6450
The SNMPv3 protocol is ascending compatible with SNMPv1 and v2
and supports all the SNMPv1 and SNMPv2 PDUs
Community Strings
None
Sets and Gets
SHA, MD5
DES
Non-authenticated Sets, Non-authenticated Gets and Get-Nexts,
Authenticated Sets, Authenticated Gets and Get-Nexts, Encrypted Sets,
Encrypted Gets and Get-Nexts
Refer to the table on page 3-10
definitions.
50
Command
snmp station
snmp community map
snmp security
snmp trap filter
snmp trap absorption
OmniSwitch 6250/6450 Switch Management Guide
for a complete list of traps and their
Default Value/Comments
UDP port 162, SNMPv3, Enabled
Enabled
Privacy all (highest) security
Disabled
Enabled
Using SNMP
June 2013