Application Example; Using A Wildcard To Filter Table Information - Alcatel-Lucent OmniSwitch 6450 Management Manual

Using the CLI

Application Example

Using a Wildcard to Filter Table Information

The wildcard character allows you to substitute the asterisk (*) character for text patterns while using the
filter mode.
Note. Type the wildcard character in front of and after the filter text pattern unless the text pattern appears
alone on a table row.
In this example, the show snmp mib family
information. This example uses the filter option to display only those lines containing the "vlan" character
pattern.
1 Use the more command to set the number of displayed lines to 10 and to enable the more mode.
-> more size 10
-> more
To verify your settings, enter the following:
-> show more
The more feature is enabled and the number of line is set to 10
2 Enter the show snmp mib family
in the More? mode as indicated at the bottom of the screen.
-> show snmp mib family
MIP ID MIB TABLE NAME
-------+----------------------------------------+---------------------
6145 esmConfTrap
6146 alcetherStatsTable
6147 esmConfTable
6148 ifJackTable
7169 dot1qPortVlanTable
7170 qAggregateVlanTable
7171 qPortVlanTable
More? [next screen <sp>, next line <cr>, filter pattern </>, quit <q>]
3 Type the filter pattern "/" command and the following message automatically appears.
Enter filter pattern:
Enter the desired text pattern, in this case "*vlan*", at the prompt. Remember to type the text exactly as it
would appear in the CLI table and to type the asterisk (*) character before and after the text. The More?
mode prompt automatically re-appears.
Enter filter pattern: *vlan*
More? [next screen <sp>*, next line <cr>*, filter pattern </>*, quit <q>]
OmniSwitch 6250/6450 Switch Management Guide
command is used because it displays a long table of MIB
command. Ten lines of information are displayed. The switch is now
June 2013
Application Example
FAMILY
NO SNMP ACCESS
interface
interface
interface
802.1Q
802.1Q
802.1Q
page 6-25