Using SNMP
Checking Configuration File Using Traps
If there are any configuration changes, a trap is sent to Service Aware Manager (SAM) to enforce a poll
when configuration file is saved. The running configuration is not saved in the configuration file
(boot.cfg) until the user commits the changes using the write memory command or
copy running-config working command. The configuration changes that are not committed are not
detected by the switch until these commands are applied.
Related traps are raised on the following commands:
• write memory
• write memory flash-synchro
• copy running-config working
OmniSwitch 6250/6450 Switch Management Guide
June 2013
Working with SNMP Traps
page 3-15