Using Authentication - Alcatel-Lucent OmniSwitch 6450 Management Manual

Configuring NTP

Using Authentication

Authentication is used to encrypt the NTP messages sent between the client and server. The NTP server
and the NTP client must both have a text file containing the public and secret keys. (This file should be
obtained from the server administrator. For more information on the authentication file, see
tion" on page 4-8.)
Once both the client and server share a common MD5 encryption key, the MD5 key identification for the
NTP server must be specified on and labeled as trusted on the client side.
Setting the Key ID for the NTP Server
Enabling authentication requires the following steps:
1 Make sure the key file is located in the /networking directory of the switch. This file must contain the
key for the server that provides the switch with its timestamp information.
2 Make sure the key file with the NTP server's MD5 key is loaded into the switch memory by issuing the
ntp key load command, as shown:
-> ntp key load
3 Set the server authentication key identification number using the
keyword. This key identification number must be the one the server uses for MD5 encryption. For exam-
ple, to specify key identification number 2 for an NTP server with an IP address of 1.1.1.1, enter:
-> ntp server 1.1.1.1 key 2
4 Specify the key identification set above as trusted. A key that has been labeled as trusted is ready for
use in the authentication process. To set a key identification to be trusted, enter the
the key identification number and trusted keyword. For example, to set key ID 5 to trusted status, enter
the following:
-> ntp key 5 trusted
Untrusted keys, even if they are in the switch memory and match an NTP server, does not authenticate
NTP messages.
5 A key can be set to untrusted status by using the
example, to set key ID 5 to untrusted status, enter the following:
-> ntp key 5 untrusted
page 4-12
Configuring Network Time Protocol (NTP)
ntp server
ntp key command with the untrusted keyword. For
OmniSwitch 6250/6450 Switch Management Guide
"Authentica-
command with the key
ntp key command with
June 2013