Alcatel-Lucent OmniSwitch 6450 Management Manual page 176

Using the CLI
3 At the command prompt, enter name followed by a space and a question mark. This step either gives
you more choices or an error message.
-> vlan 33 name ?
^
<hex> <"string"> <string>
(Vlan Manager Command Set)
There is a smaller set of keywords available for use with the vlan 33 name syntax. This is because the
command becomes more specialized as more keywords are added. From the choices shown on the screen,
you can enter a hex value, a text string enclosed in quotes (" ") or a text string without quotes. In this case,
the name selected for the VLAN includes spaces so use the syntax enclosed in quotes.
4 At the command prompt, enter the name of the VLAN enclosed in quotes, followed by a space and a
question mark.
-> vlan 33 name "test vlan 2" ?
(Vlan Manager Command Set)
When the question mark is issued this time, the only syntax listed is <cr>. This means that the command
syntax is complete. When you press Enter, the command is issued.
Note. Optional. To verify that the command was accepted, enter the show vlan command. The display is
similar to the one shown here.
-> show vlan
vlan admin oper
-----+-------+------+-------+------+----+-----+---------------------------------
1 on
33 on
The second entry verifies that a VLAN was created, the VLAN ID is 33, and the name is test vlan 2.
OmniSwitch 6250/6450 Switch Management Guide
^
<cr>
stree auth
off on off
off on off
June 2013
ip name
off VLAN 1
off test vlan 2
Command Help
page 6-10