Setting An Application Session For A Specified Time Period - Alcatel-Lucent OmniSwitch 6450 Management Manual

Working With Configuration Files
Note. Optional. To verify that the switch received this
show configuration status
-> show configuration status
File configuration </flash/working/bncom_cfg.txt>: scheduled at 07/04/02 09:00
For more information about this display see "Configuration File Manager Commands" in the OmniSwitch
6250/6450 CLI Reference Guide.

Setting an Application Session for a Specified Time Period

You can set a future timed session to apply a configuration file after a specified period of time has elapsed.
In the following example, the amzncom_cfg.txt will be applied after 6 hours and 15 minutes have
elapsed.
1 Verify that there are no current timer sessions pending on the switch.
-> show configuration status
File configuration: none scheduled
2 Apply the file by executing the
time frame specified.
-> configuration apply amzncom_cfg.txt in 6:15
Note. Optional. To verify that the switch received this
show configuration status
-> show configuration status
File configuration </flash/working/amzncom_cfg.txt>: scheduled at 03/07/02 05:02
The "scheduled at" date and time show when the file will be applied. This value is 6 hours and 15 minutes
from the date and time the command was issued.
For more information about this display see "Configuration File Manager Commands" in the OmniSwitch
6250/6450 CLI Reference Guide.
OmniSwitch 6250/6450 Switch Management Guide
command. The display is similar to the one shown here.
configuration apply
command. The display is similar to the one shown here.
June 2013
Quick Steps for Applying Configuration Files
configuration apply request, enter the
command using the in keyword with the relevant
configuration apply request, enter the
page 7-5