Directory Commands; Determining Your Location In The File Structure - Alcatel-Lucent OmniSwitch 6450 Management Manual

File and Directory Management

Directory Commands

The directory commands are applied to the switch file system and to files contained within the file system.
When you first enter the flash directory, your login is located at the top of the directory tree. You may
navigate within this directory by using the
login within the directory structure is called your current directory. You need to observe your login
location because when you issue a command, that command applies only to directories and files in your
current directory unless another path is specified.
The following drawing is a logical representation of the OmniSwitch file directory shown in the illustra-
tion on page 1-5.
Certified Directory
(Files)
Ksecu.img
Kos.img
Krelease.img
boot.cfg

Determining Your Location in the File Structure

Use the pwd command to display the path to your current directory. When you first log into the switch,
your current directory is the flash directory. If you enter the
displayed:
-> pwd
/flash
->
The display shows the name of the current directory and its path. If your current directory is the certified
directory and you enter the
-> pwd
/flash/certified
->
The display shows the path to your current directory.
page 1-8
pwd and cd
Flash Directory
Working Directory
(Files)
Ksecu.img
Kbase.img
boot.cfg
Sample Switch Directory Tree
pwd command, the following will be displayed:
OmniSwitch 6250/6450 Switch Management Guide
commands (discussed below). The location of your
Network Directory
(File)
policy.cfg
pwd command, the following will be
Managing System Files
(Files)
boot.params
cs_system.pmd
boot.slot.cfg
boot.cfg.1.err
swlog.1.log
swlog2.log
June 2013