Quick Steps For Network Administrator User Accounts - Alcatel-Lucent OmniSwitch 6450 Management Manual

Managing Switch User Accounts

Quick Steps for Network Administrator User Accounts

1 Configure the user with the relevant username and password. For example, to create a user called
thomas with a password of techpubs, enter the following:
-> user thomas password techpubs
For information about creating a user and setting up a password, see
2 Configure the user privileges (and SNMP access) if the user must have privileges that are different than
those set up for the default user account. For example:
-> user thomas read-write domain-network ip-helper telnet
For information about the default user settings, see the next section. For information about setting up priv-
ileges, see "Configuring Privileges for a User" on page
Note. Optional. To verify the user account, enter the
following:
User name = admin,
Password expiration
Password allow to be modified date
Account lockout
Password bad attempts
Read Only for domains
Read/Write for domains
Snmp allowed
User name = default (*),
Password expiration
Password allow to be modified date
Account lockout
Password bad attempts
Read Only for domains
Read/Write for domains
Snmp allowed
User name = public (*),
Password expiration
Password allow to be modified date
Account lockout
Password bad attempts
Read Only for domains
Read/Write for domains
Snmp allowed
(*)Note:
The default user is not an active user account.
It constains the default user account settings,
for new user accounts.
For more information about the show user command, see the OmniSwitch 6250/6450 CLI Reference
Guide.
OmniSwitch 6250/6450 Switch Management Guide
= None,
= None,
= 1,
= None,
= All ,
= NO
= None,
= None,
= 0,
= None,
= None,
= NO,
= None,
= None,
= 0,
= None,
= None,
= NO,
June 2013
"Creating a User" on page
9-27.
show user command. The display is similar to the
= None,
= None,
= None,
Overview of User Accounts
9-12.
page 9-7