Alcatel-Lucent OmniSwitch 6450 Management Manual page 52

Application Examples for File Management
3 Enter the FTP mode by using the
are connecting to. (If you enter a host name, please refer to
->ftp 10.255.11.101
220 Connecting to [10.255.11.101]...connected.
Cosmo Windows FTP server ready
Name: Myhost1
Note. You can only use a host name instead of an IP address if the DNS resolver has been configured and
enabled. If not, you must specify an IP address.
You can use the ftp6
FTPv6 session over an IPv6 environment. For example:
-> ftp6 fe80::a00:20ff:fea8:8961 intf1
220 Connecting to [fe80::a00:20ff:fea8:8961]...connected.
Cosmo Windows FTP server ready
Name: Myhost1
Note. FTPv6 sessions are supported. It is mandatory to specify the name of the particular IPv6 interface, if
the FTPv6 server has been specified using its link-local address.
4 Enter a valid user name and password for the host you specified with the
similar to the following is displayed:
Name (d) : Jsmith
331 Password required for Jsmith
Password: *****
230 User Jsmith logged in.
5 Use the FTP "put" command to transfer the file from your switch to the host as shown here.
ftp> put rrtest.txt
The following will be displayed:
200 Port set okay
150 Opening BINARY mode data connection
Transferred 20 octets in 1 seconds.
226 Transfer complete
ftp>
6 To exit the switch FTP client mode, use the "quit" FTP command. Your current directory on the switch
is /flash/working, which is the location from which you initiated the FTP client session. Use the
command to verify your current directory.
ftp> quit
221 Bye
-> pwd
/flash/working
page 1-32
ftp command followed by the IP address or the name of the host you
command followed by the IPv6 address or hostname of the FTPv6 server to start an
OmniSwitch 6250/6450 Switch Management Guide
"Using Zmodem" on page
ftp command. A screen
Managing System Files
1-25.)
pwd CLI
June 2013