Alcatel-Lucent OmniSwitch 6450 Management Manual page 197

Working With Configuration Files
4 Use the show configuration status
applied to the switch. The display is similar to the one shown here:
-> show configuration status
File configuration <dhcp_relay.txt>: completed with no errors
File configuration: none scheduled
Running configuration and saved configuration are different
Note. If the configuration file applied with the
saved configuration, the message will state that the running configuration and saved configuration are
identical. To synchronize the running configuration and the saved configuration, use the
command.
For more information about these displays, refer to the OmniSwitch 6250/6450 CLI Reference Guide.
5 Use a the show ip helper
ration files were actually implemented on the switch. The display is similar to the one shown here:
-> show ip helper
Forward Delay (seconds) = 15
Max number of hops
Forwarding option
Forwarding Address:
128.251.16.52
These results confirm that the commands specified in the file dhcp_relay.txt configuration file were
successfully applied to the switch.
OmniSwitch 6250/6450 Switch Management Guide
command to verify that the dhcp_relay.txt configuration file was
configuration apply
command to verify that the DHCP Relay parameters defined in the configu-
= 3
= standard
June 2013
Tutorial for Creating a Configuration File
command results in no changes to the
write memory
page 7-3