Quick Steps For Creating Customer Login User Accounts - Alcatel-Lucent OmniSwitch 6450 Management Manual

Overview of User Accounts

Quick Steps for Creating Customer Login User Accounts

1 Set up a user profile through the
Profile1 that specifies read-write access to the physical and basic-ip-routing command areas:
-> end-user profile Profile1 read-write physical basic-ip-routing
2 Specify ports to which the profile will allow access. In this example, Profile1 will be configured with
access to ports on slot 1 and slot 2.
-> end-user profile Profile1 port-list 1/1-2 1/4-5 2/1-8
3 Specify VLANs or VLAN ranges to which the profile will allow access. In this example, Profile1 will
be configured with access to VLANs 3 through 8.
-> end-user profile Profile1 vlan-range 3-8
Note. Optional. To verify the end-user profile, enter the
similar to the following:
End user profile : Profile1
Area accessible with read and write rights :
physical,
basic ip routing,
Slot : 1, ports allowed : 1-2, 4-5
Slot : 2, ports allowed : 1-8
Vlan Id :
3-8
For more information about the show end-user profile command, see the OmniSwitch 6250/6450 CLI
Reference Guide.
4 Associate the profile with a user account. Enter the user command with the relevant username and
password and specify Profile1. In this example, the user name is Customer1 and the password is
my_passwd:
-> user Customer1 password my_passwd end-user profile Profile1
For more information about creating a user and setting up a password, see
For information about creating end-user profiles, see
Note. Optional. To verify the user account, enter the
following:
User name = Customer1
END user profile
SNMP authentication
User name = default
END user profile
Snmp not allowed
For more information about the show user command, see the OmniSwitch 6250/6450 CLI Reference
Guide.
page 9-8
aaa admin-logout command. For example, configure a profile called
show end-user profile
"Setting Up End-User Profiles" on page
show user
= Profile1
= NONE, Snmp encryption = NONE
Profile5
OmniSwitch 6250/6450 Switch Management Guide
Managing Switch User Accounts
command. The display is
"Creating a User" on page
command. The display is similar to the
9-12.
9-32.
June 2013