Alcatel-Lucent OmniSwitch 6450 Management Manual page 280

Quick Steps for Setting Up ASA
The order of the server names is important here as well. In this example, the switch will use ldap2 for
logging switch access sessions. If ldap2 becomes unavailable, the switch will use the local Switch
Logging facility. For more information about Switch Logging, see the
OmniSwitch 6250/6450 Network Configuration Guide.
Note. To verify the switch access setup, enter the
similar to the one shown here:
Service type = Default
1rst authentication server
2nd authentication server
Service type = Console
Authentication = Use Default,
1rst authentication server
2nd authentication server
Service type = Telnet
Authentication = Use Default,
1rst authentication server
2nd authentication server
Service type = Ftp
Authentication = Use Default,
1rst authentication server
2nd authentication server
Service type = Http
Authentication = denied
Service type = Snmp
Authentication = Use Default,
1rst authentication server
2nd authentication server
Service type = Ssh
Authentication = Use Default,
1rst authentication server
2nd authentication server
For more information about this command, see the OmniSwitch 6250/6450 CLI Reference Guide.
page 10-8
show aaa authentication
= rad1
= local
= rad1
= local
= rad1
= local
= rad1
= local
= rad1
= local
= rad1
= local
OmniSwitch 6250/6450 Switch Management Guide
Managing Switch Security
command. The display is
June 2013