Configuring Login Parameters; Configuring The Inactivity Timer - Alcatel-Lucent OmniSwitch 6450 Management Manual

Logging Into the Switch

Configuring Login Parameters

You can set the number of times a user may attempt unsuccessfully to log in to the switch's CLI by using
the session login-attempt
-> session login-attempt 5
In this example, the user may attempt to log in to the CLI five (5) times unsuccessfully. If the user
attempts to log in the sixth time, the switch will break the TCP connection.
You may also set the length of time allowed for a successful login by using the
command as follows:
-> session login-timeout 20
In this example, the user must complete the login process within 20 seconds. This means that the time
between a user entering a login name and the switch processing a valid password must not exceed 20
seconds. If the time-out period exceeds, the switch will break the TCP connection.

Configuring the Inactivity Timer

You can set the amount of time that a user must be inactive before the session times out. By default, the
time-out for each session type is 4 minutes. To change the setting, enter the
with the type of session (cli, http, or ftp) and the desired number of minutes. In the following example,
the CLI time-out is changed from the default to 8 minutes.
-> session timeout cli 8
This command changes the inactivity timer for new CLI sessions to 8 minutes. Current CLI sessions are
not affected. In this example, current CLI sessions will be timed out after 4 minutes. (CLI sessions are
initiated through Telnet, Secure Shell, or through the switch console port.)
For information about connecting to the CLI through Telnet or Secure Shell, see
page 2-8 and "Using Secure Shell" on page
console port, see your Getting Started Guide. For information about using the CLI in general, see
Chapter 6, "Using the CLI."
The ftp option sets the time-out for FTP sessions. For example, to change the FTP time-out to 5 minutes,
enter the following command:
-> session timeout ftp 5
This command changes the time-out for new FTP sessions to 5 minutes. Current FTP sessions are not
affected. For more information about FTP sessions, see
The http option sets the time-out for WebView sessions. For example, to change the WebView inactivity
timer to 10 minutes, enter the following command:
-> session timeout http 10
In this example, any new WebView session will have a time-out of 10 minutes. Current WebView
sessions are not affected. For more information about WebView sessions, see
WebView."
OmniSwitch 6250/6450 Switch Management Guide
command as follows:
2-12. For information about connecting to the CLI through the
June 2013
Configuring Login Parameters
session login-timeout
session timeout
"Using FTP" on page 2-10.
Chapter 11, "Using
command
"Using Telnet" on
page 2-23