Alcatel-Lucent OmniSwitch 6450 Management Manual page 342

SNMP Traps Table
No. Trap Name
55 alaStackMgrClearedSlotTrap
alaStackMgrSlotNINumber—Numbers allocated for the stack NIs as follows:
- 0: invalid slot number
- 1..8: valid and assigned slot numbers corresponding to values from the entPhysicalTable
- 1001..1008: switches operating in pass through mode
- 255: unassigned slot number.
56 alaStackMgrOutOfSlotsTrap
57 alaStackMgrOutOfTokensTrap
alaStackMgrSlotNINumber—Numbers allocated for the stack NIs as follows:
- 0: invalid slot number
- 1..8: valid and assigned slot numbers corresponding to values from the entPhysicalTable
- 1001..1008: switches operating in pass through mode
- 255: unassigned slot number.
58 alaStackMgrOutOfPassThruSlotsTrap N/A
59 gmHwVlanRuleTableOverloadAlert
gmOverloadRuleTable—Overloaded hardware VLAN rule table.
gmOverloadRuleType—VLAN rule types that are not configured due to the overload of the hardware VLAN
rule table.
gmOverloadRuleVlanId—The overloaded VLAN ID.
gmOverloadRuleMacAddress—The overloaded MAC address.
gmOverloadRuleIpAddress—The overloaded IP address.
gmOverloadRuleProtocol—The overloaded protocol type.
page B-14
Objects Family
alaStack- chassis
MgrSlotNI-
Number
N/A chassis
alaStack- chassis
MgrSlotNI-
Number
chassis
gmOverloadRu- vlan
leTable
gmOverloadRu-
leType
gmOverloadRu-
leVlanId
gmOverloadRu-
leMacAddress
gmOverloadRu-
leIpAddress
gmOverloadRu-
leProtocol
OmniSwitch 6250/6450 Switch Management Guide
SNMP Trap Information
Description
The element identified by
alaStackMgrSlotNINumber will
enter the pass through mode
because its operational slot was
cleared with immediate effect.
One element of the stack will
enter the pass through mode
because there are no slot num-
bers available to be assigned to
this element.
The element identified by
alaStackMgrSlotNINumber will
enter the pass through mode
because there are no tokens
available to be assigned to this
element.
There are no pass through slots
available to be assigned to an ele-
ment that is supposed to enter the
pass through mode.
An overload trap occurs when-
ever a new entry to the hardware
VLAN rule table gets dropped
due to the overload of the table.
June 2013