NEC SOPHO IP 5000 Command Reference Manual page 82

debugging ntp-service
Command Reference Guide
view or multi-user interface view.
Example
Enter the user-interface console 0 view to configure console 0.
[NEC-PHILIPS] user-interface console 0
[NEC-PHILIPS-ui-console0]
Enter the user-interface vty 0 view to configure vty 0.
[NEC-PHILIPS] user-interface vty 0
[NEC-PHILIPS-ui-vty0]
Enter the user-interface vty view to configure user-interfaces vtys 0 through 3.
[NEC-PHILIPS] user-interface vty 0 3
[NEC-PHILIPS-ui-vty0-3]
enter the user-interface view to configure user-interfaces 0 through 4, including
of console port type, of AUX interface type and of VTY interface type. The user
interface types will be configured depending on the configuration interface
available on the router.
The following example configures one console user interface and three VTY
user interfaces, which may be right for the case where the router does not
provide the AUX interface.
[NEC-PHILIPS] user-interface 0 3
[NEC-PHILIPS-ui0-3]
Syntax
debugging ntp-service { access | adjustment | authentication | event | filter
| packet | parameter | refclock | selection | synchronization | validity | all }
undo debugging ntp-service { access | adjustment | authentication | event
| filter | packet | parameter | refclock | selection | synchronization | validity
| all }
View
User view
Parameter
access: NTP access control debugging.
adjustment: NTP clock adjustment debugging.
all: All the NTP information debugging.
authentication: NTP identification authentication debugging.
event: NTP event debugging.
filter: NTP filter information debugging.
packet: NTP packet debugging.
parameter: NTP clock parameter debugging.
refclock: NTP reference clock debugging.
SOPHO
IP 5000/SOPHO IP6000
82