NEC SOPHO IP 5000 Command Reference Manual page 40

display schedule reboot
remove slot
Command Reference Guide
card, power module, and fan module, as well as the offline information of MPU
and NPU.
Executing the command defined without parameters will display the essential
information of all the devices in position. Executing the command defined with
the parameter slot-number will display only the details on the defined slot,
including reset times and history records of the reset causes.
Example
Display the essential information of the router.
<NEC-PHILIPS> display device
Slot # Type Online
0 RPU Present
6 PWR Present
7 FAN Present
Syntax
display schedule reboot
View
Any view
Parameter
None
Description
Using the display schedule reboot command, you can check the configuration
of related parameters of the router schedule reboot terminal service. For the
related command, see reboot, schedule reboot at, schedule reboot
delay, undo schedule reboot.
Example
Display the configuration of the schedule reboot terminal service parameters of
the current router.
<NEC-PHILIPS> display schedule reboot
Reboot system at 16:00:00 2002/11/1 (in 2 hours and 5 minutes).
Syntax
remove slot slotnum
undo remove slot slotnum
View
User view
Parameter
slotnum: Slot number for the interface card
Description
Using the remove slot command, you can run pre-processing before removing
an interface card. You can also cancel a misoperation with the undo remove
slot command if you change your mind to remove the card after executing the
remove slot command.
The undo remove slot command is unnecessary when you remove a card, but
insert it immediately.
For the related command, see reboot, schedule reboot at, schedule reboot
SOPHO
Status
Normal
Normal
Normal
IP 5000/SOPHO IP6000
40