NEC SOPHO IP 5000 Command Reference Manual page 13

lock
quit
Command Reference Guide
Syntax
lock
View
User view
Parameter
None
Description
Using the lock command, you can lock the active user interface to prevent an
unauthorized user from operating the interface.
A user interface includes CON port, AUX port and VTY, etc.
After inputting the lock command, the user is prompted to enter the
screensaver's password and confirm the password. If the two passwords are
the same, the interface will be successfully locked. To enter the system once
again, you must press <Enter> first, and enter the preset password following the
prompt.
Example
Log in from the CON port and lock the active user interface.
<NEC-PHILIPS> lock
Password:
Again:
Syntax
quit
View
Any view
Parameter
None
Description
Using the quit command, you can quit from the active view to a lower-level view
(if the active view is user view, you will exit the system).
Views fall into three levels; in ascending order:
■ User view (with user level as 0)
■ System view (with user level as 3)
■ and Configuration view (routing protocol view, interface view, VPDN group
view, etc).
For the related command, see return.
Example
Switch from Ethernet1/0/0 interface view to system view, and then to user view.
[NEC-PHILIPS-Ethernet1/0/0] quit
[NEC-PHILIPS] quit
<NEC-PHILIPS>
SOPHO
IP 5000/SOPHO IP6000
13