Fundamental Ce3 Interface Configuration Commands - NEC SOPHO IP 5000 Command Reference Manual

4.8

Fundamental CE3 Interface Configuration Commands

clock
Command Reference Guide
Parameter
all: Binds all the time slots on an interface. The interface rate will become 24 X
64kbps (that is, 1536kbps) after binding.
range: Time slots participating in the binding operation. It is in the range of 1 to
24. When specifying time slots for binding, you can configure a single time slot
by using the form of "number", the time slots in a range by using the form of
"number1-number2", or multiple time slots by using the form of "number1,
number2-number3".
speed { 56 | 64 }: Speed in kbps, which is used for time slot binding. If the
argument 56 is used, timeslots will be bound into N X 56kbps. If the argument
64 is used, timeslots will be bound into N X 64kbps.
Description
Using the ft1 timeslot-list command, you can configure the time slots that will
participate in the binding operation on a T1-F interface. Using the undo ft1
timeslot-list command, you can restore the default setting of time slot binding.
By default, all the time slots on a T1-F interface are bound. That is, the T1-F
interface rate defaults to 1536kbps.
When performing time slot binding on a T1-F interface, the speed assigned to a
time slot defaults to 64kbps.
The time slot binding operation on a T1-F interface results in a change of
interface rate. For example, after the user binds the time slots 1 through 10, the
interface rate becomes 10 X 64kbps (or 10 X 56 kbps).
Example
Bind the time slots 1, 2, 5, 10 through 15, and 18 on the T1-F interface.
[NEC-PHILIPS-Serial0/0/0] ft1 timeslot-list 1,2,5,10-15,18
Syntax
clock { master | slave }
undo clock
View
CE3 interface view
Parameter
master: Adopts the internal clock mode.
slave: Adopts the line clock mode.
Description
Using the clock command, you can set the clock mode on a CE3 interface.
Using the undo clock command, you can restore the default clock mode on
the interface.
By default, the CE3 interface adopts the line clock mode (slave).
The clock is selected depending on the connected remote device. If it is a
transmission device, the local end will use the line clock.
SOPHO
IP 5000/SOPHO IP6000
152