NEC SOPHO IP 5000 Command Reference Manual page 107

snmp-agent usm-user
Command Reference Guide
Parameter
interface-type: Interface type. interface-number: Interface number. subinterface-
name: Subinterface type.
Description
Using the snmp-agent trap source command, you can specify the source
address from which Trap will be sent. Using the undo snmp-agent trap source
command, you can remove the Trap source address.
There is always a Trap address when the SNMP Trap message is being sent
from a server, no matter from which interface it is sent. This command can be
used to trace a special event.
For the related command, see snmp-agent trap enable, snmp-agent target-
host.
Example
Specify the IP address of the Ethernet interface 1/0/0 as the source address of
Trap packet.
[NEC-PHILIPS] snmp-agent trap source ethernet 1/0/0
Syntax
snmp-agent usm-user { v1 | v2c } user-name group-name [ acl acl-number
]
undo snmp-agent usm-user { v1 | v2c } user-name group-name
snmp-agent usm-user v3 user-name group-name [ [ authentication-mode {
md5 | sha } auth-password ] [ privacy des56 priv-password ] ] [ acl acl-
number ]
undo snmp-agent usm-user v3 user-name group-name { local | engineid
engineid-string }
View
System view
Parameter
v1: V1 security mode the user uses.
v2c: V2C security mode the user uses.
v3: V3 security mode the user uses.
user-name: User name, in the range of 1 to 32 bytes.
group-name: Group name the user is corresponding to, in the range of 1 to 32
bytes.
authentication-mode: Specifies the security level as requiring authentication.
md5: Specifies the authentication protocol as HMAC-MD5-96.
sha: Specifies the authentication protocol as HMAC-SHA-96.
auth-password: Authentication password, which is a character string in the
range of 1 to 64 bytes.
privacy: Specifies the security level as encrypted.
des56: Specifies the encryption protocol as DES.
SOPHO
IP 5000/SOPHO IP6000
107