NEC SOPHO IP 5000 Command Reference Manual page 187

ppp mp mp-group
Command Reference Guide
This command is used in concert with the ppp mp mp-group command. Either
MP-group interface or interface added in MP group can be configured first.
Example
Create MP-group interface 3/0/0.
[NEC-PHILIPS] interface mp-group 3/0/0
[NEC-PHILIPS-mp-group 3/0/0]
Syntax
ppp mp mp-group number
undo ppp mp mp-group number
View
Interface view
Parameter
number: Number of MP-group interface
Description
Using the ppp mp mp-group command, you can add the current interface to a
specified MP group. Using the undo ppp mp mp-group command, you can
remove the current interface from a specified MP group.
This command is used with the interface mp-group command. Either MP-group
interface or interface added in MP group can be configured first.
It should be noted that the interface added to an MP group must be consistent
with the slot of the MP-group interface.
In addition, the interface added to an MP group must be a physical interface.
Tunnel interfaces do not support this command.
Example
Add serial port 3/0/0 to MP group 3.
[NEC-PHILIPS] interface serial 3/0/0
[NEC-PHILIPS-Serial3/0/0] ppp mp mp-group 3/0/0
Remove serial port 3/0/0 from MP group 3/0/0.
[NEC-PHILIPS-Serial3/0/0] undo ppp mp mp-group 3/0/0
SOPHO
IP 5000/SOPHO IP6000
187