NEC SOPHO IP 5000 Command Reference Manual page 71

databits
Command Reference Guide
command command:
■ CON does not support auto-execute command.
■ If there is only AUX but no CON on a router (AUX and CON shares the
same port), the AUX will not support auto-execute command as well.
These constraints do not apply to other types of user interfaces.
When a user logs on, some command configured using auto-execute
command on the terminal will automatically be executed. The user connection
will be disconnected automatically once the execution of the command is
finished.
A common approach is to configure the Telnet command using the auto-
execute command command on the terminal so that the user may
automatically connect to the specified host.
You should use this command with caution because it will probably make you
unable to make the regular system configurations via this user interface.
CAUTION: Before configuring the auto-execute command command and
saving the configuration (by executing the save command), you should make
sure that you can access the system to remove the configuration by other
means.
Example
Execute the telnet 10.110.100.1 command automatically after the user logs on
from the AUX interface.
[NEC-PHILIPS-ui-aux0] auto-execute command telnet 10.110.100.1
Syntax databits { 5 | 6 | 7 | 8 }
undo databits
View
User interface view
Parameter
5: Five data bits.
6: Six data bits.
7: Seven data bits.
8: Eight data bits.
Description
Using the databits command, you can set user interface data bit. Using the
undo databits command, you can restore the default data bit setting.
By default, data bit is set to 8.
The configuration can take effect only when the serial interface works in the
asynchronous flow mode.
Example
Set data bit to 5.
[NEC-PHILIPS-ui-aux0] databits 5
SOPHO
IP 5000/SOPHO IP6000
71