NEC SOPHO IP 5000 Command Reference Manual page 20

ping
Command Reference Guide
Internet protocol processing : disabled
Encapsulation is PPP
LCP initial FIFO queuing: (Outbound queue:Size/Length/Discards)
FIFO: 0/75/0
Physical layer is synchronous, Baudrate is 64000 bps, Interface is no cable
5 minutes input rate 0.00 bytes/sec, 0.00 packets/sec
5 minutes output rate 0.00 bytes/sec, 0.00 packets/sec
0 packets input, 0 bytes, 0 no buffers
0 packets output, 0 bytes, 0 no buffers
0 input errors, 0 CRC, 0 frame errors
0 overrunners, 0 aborted sequences, 0 input no buffers
DCD=DOWN DTR=DOWN DSR=DOWN RTS=DOWN CTS=DOWN
Syntax
ping [ -a X.X.X.X | -c count | -d | -h ttl_value | -i { interface-type interface-
number } | ip | -n | - p pattern | -q | -r | -s packetsize | -t timeout | -v | vpn-
instance vpn-instance-name ] * host
View
Any view
Parameter
-a X.X.X.X: Sets the source IP address where ICMP ECHO-REQUEST packets
can be sent.
-c count: Times that ICMP ECHO-REQUEST packets are sent. It is ranging
from 1 to 4294967295.
-d: Sets socket to DEBUG mode.
-h ttl_value: Sets the value of TTL_value, which is ranging from 1 to 255.
-i: Sets the interface for sending ICMP ECHO-REQUEST packets.
interface-type: Interface type
interface-number: Interface number
-n: Directly uses the host parameter as IP address without domain name
resolution.
-p pattern: The filling byte of ICMP ECHO-REQUEST packet in hexadecimal
format, with the value ranging from 0 to FFFFFFFF. For example, if the
parameter is set to -p ff, the entire packet will be filled with ff.
-q: Displays statistic figures rather than details.
-r: Records routes.
-s packetsize: The length of ECHO-REQUEST packet (excluding IP and ICMP
headers), which is in the range of 20 to 8100 bytes.
-t timeout: Timeout in milliseconds waiting for ECHO-RESPONSE upon
completion of sending ECHO-REQUEST, in the range from 0 to 65535.
-v: Displays the received ICMP packets other than ECHO-RESPONSE packets.
vpn-instance vpn-instance-name: Sets the vpn-instance name of MPLS VPN
to specify the VPN attribute configured in this ping command, that is, name of
the associated vpn-instance created at the local.
host: Domain name or IP address of destination host.
ip: IP protocol is used.
Description
Using the ping command, you can check the IP network connection and
whether the host is reachable.
SOPHO
IP 5000/SOPHO IP6000
20