NEC SOPHO IP 5000 Command Reference Manual page 147

fe1 loopback
fe1 timeslot-list
Command Reference Guide
Syntax
fe1 loopback { local | remote }
undo fe1 loopback [ local | remote ]
View
E1-F interface view
Parameter
local: Places the interface in local loopback.
remote: Places the interface in remote loopback.
Description
Using the fe1 loopback command, you can configure an E1-F interface in local
or remote loopback. Using the undo fe1 loopback command, you can disable
the local and remote loopback on the interface.
By default, the interfaces are not placed in local or remote loopback.
Local loopback and remote loopback are used for testing the state of interface
or cable itself. These functions should be disabled in normal cases. On an
interface, using this command, but with different arguments, can enable local
loopback and remote loopback, but these two functions cannot be enabled at
the same time.
Example
Place the E1-F interface in local loopback.
[NEC-PHILIPS-Serial0/0/0] fe1 loopback local
Syntax
fe1 timeslot-list { all | range }
undo fe1 timeslot-list
View
E1-F interface view
Parameter
all: Binds all the time slots on an interface, the interface rate will become 31 X
64kbps (that is, 1984kbps) after binding.
range: Time slots participating in the binding operation, it is in the range of 1 to
31. When specifying time slots for binding, you can configure a single time slot
by using the form of "number", the time slots in a range by using the form of
"number1-number2", or multiple time slots by using the form of "number1,
number2-number3".
Description
Using the fe1 timeslot-list command, you can configure the time slots that will
participate in the binding operation on an E1-F interface. Using the undo fe1
timeslot-list command, you can restore the default setting of time slot binding.
By default, all the time slots on an E1-F interface are bound. That is, the E1-F
interface rate defaults to 1984kbps.
Time slot binding operation on an E1-F interface will result in changing of
interface rate. For example, after the user binds the time slots 1 through 10, the
interface rate will become 10 X 64kbps.
SOPHO
IP 5000/SOPHO IP6000
147