NEC SOPHO IP 5000 Command Reference Manual page 178

adsl standard
Command Reference Guide
disappear upon the deactivation of the ADSL port. To transport new services,
you must re-activate the port.
This command is used to manually activate/deactivate an ADSL line for the
purpose of testing and troubleshooting.
The commands activate/undo activate and shutdown/undo shutdown are
different because the former can only take effect on ADSL lines.
You should note that ADSL is always online, which is different from DCC.
Therefore, after the device is booted, the ADSL interface will automatically
enable the activation task and enter the active state. It will stay active as long
as the line is in good condition. The router tests the line performance at a
regular interval and will automatically deactivate the line and perform a new
training and re-activation
deteriorated.
Example
Deactivate the ADSL interface.
[NEC-PHILIPS-Atm1/0]undo activate
Syntax
adsl standard { auto | gdmt | glite | t1413 }
undo adsl standard
View
ADSL interface view
Parameter
auto: Auto-sensing mode.
gdmt: Adopts the G.DMT(G992.1) standard.
glite: Adopts the G.Lite (G992.2) standard.
t1413: Adopts the T1.413 standard.
Description
Using the adsl standard command, you can set the standard applied to an
ADSL interface. Using the undo adsl standard command, you can restore the
default standard used by the ADSL interface.
By default, the ADSL standard is set to auto.
You should note that this configuration does not take effect unless you activate
the interface again. If you want to make it take effect immediately, you can
execute the shutdown/undo shutdown command or the activate/undo
activate command.
Example
Set the standard for the interface atm1/0/0 as T1.413.
[NEC-PHILIPS-Atm1/0/0]adsl stand t1413
[NEC-PHILIPS -Atm1/0/0]shutdown
Interface Atm1/0/0 has already been shutdown
[NEC-PHILIPS -Atm1/0/0]undo shutdown
[NEC-PHILIPS -Atm1/0/0]
%Nov 20 21:17:12 2003 5680 PHY/2/PHY:
%Nov 20 21:17:13 2003 5680 IFNET/5/UPDOWN:
SOPHO
once it finds out that the line performance has
Atm1/0: change status to up
IP 5000/SOPHO IP6000
178