NEC SOPHO IP 5000 Command Reference Manual page 167

clock
display interface atm
Command Reference Guide
Description
Using the cable command, you can configure the cable mode of the ATM T3
cable, to set the distance between the router and the cable distribution frame.
Using the undo cable command, you can restore the default setting.
By default, short distance mode is used.
Example
Set the cable length mode of ATM T3 1/0/0 to long.
<NEC-PHILIPS> system-view [NEC-PHILIPS] interface atm 1/0/0
[NEC-PHILIPS-Atm1/0/0] cable long
Syntax
clock { master | slave }
undo clock
View
ATM E3/T3 interface view.
Parameter
master: Sets the clock mode of ATM E3/T3 to master mode.
slave: Sets the clock mode of ATM E3/T3 to slave mode.
Description
Using the clock command, you can set the clock mode of ATM E3/T3 interface.
Using the undo clock command, you can restore the default setting.
By default, the clock mode of ATM E3/T3 interface is slave mode.
Example
Set clock mode of ATM E3/T3 interface 2/0/0 as master.
<NEC-PHILIPS> system-view
[NEC-PHILIPS] interface atm 2/0/0
[NEC-PHILIPS-Atm2/0/0] clock master
Syntax
display interface atm [ interface-number ]
View
Any view
Parameter
interface-number: Interface number of ATM E3/T3.
Description
Using the display interface atm command, you can view the configuration and
status of ATM E3/T3 interface. If no interface-number is specified, the system
will display the configuration and status of all ATM interfaces.
Example
View the configuration and status of ATM E3/T3 interface 1/1/0.
<NEC-PHILIPS> display interface atm 1/1/0
SOPHO
IP 5000/SOPHO IP6000
167