NEC SOPHO IP 5000 Command Reference Manual page 86

ntp-service
authentication enable
ntp-service -
authentication keyid
Command Reference Guide
Enable the peer in No.28 access list to perform time request, query control on
the local device.
[NEC-PHILIPS] ntp-service access server 28
Syntax
ntp-service authentication enable
undo ntp-service authentication enable
View
System view
Parameter
None
Description
Using the ntp-service authentication enable command, you can set NTP-
service ID authentication. Using the undo ntp-service authentication enable
command, you can remove NTP-service ID authentication.
By default, no ID authentication is set.
Example
Enable NTP ID authentication.
[NEC-PHILIPS] ntp-service authentication enable
Syntax
ntp-service authentication-keyid number authentication-mode md5 value
undo ntp-service authentication-keyid number
View
System view
Parameter
number: Key number in the range of 1 to 4294967295.
value: Key itself that is represented with 1 to 32 ASCII characters.
Description
Using the ntp-service authentication-keyid command, you can set NTP
authentication key. Using the undo ntp-service authentication-keyid
command, you can remove NTP authentication key.
By default, no authentication key is set.
This command is used to set NTP authentication key, which only supports MD5
authentication.
Example
Set MD5 ID authentication key. The key ID number is 10 and the key is
BetterKey.
[NEC-PHILIPS] ntp-service authentication-keyid 10 authentication-mode
md5 BetterKey
SOPHO
IP 5000/SOPHO IP6000
86