Using Block Mode (Block Job); Resetting An Existing Job To The Factory Setting (Reset Job) - EWM PHOENIX 301 EXPERT forceArc Operating Instructions Manual

5.9.2.4

Using Block mode (Block JOB)

This function is only appropriate for use in combination with the M3.70 wire feed unit control and
a Powercontrol program torch.
See also the "Powercontrol program torch with one rocker (special function)" chapter
Operating
element
V
A
M
Job Nr
Hold
S
Superpuls
5.9.2.5

Resetting an existing JOB to the factory setting (Reset JOB)

If a pre-programmed JOB (JOB 1 to 128) has been changed accidentally, it is possible to reset it to
the factory settings.
Control element Action
V
A
M
Job Nr
Hold
S
Superpuls
Item No.: 099-004833-EWM01
Action Result
Select "Special Mode"
1 x
1 x
2 x
1 x
Select the Block JOB function using the
and "Down" buttons (left)
Switch Block JOB on or off using
"Down" buttons (right).
1 = Block JOB function switched on
0 = Block JOB function switched off
Save change
1 x
Exit "Special Mode"
1 x
Result
Select Job Manager mode
3 x
Select the Job Reset function using the key
x x
buttons
Select the job (JOB1-128) to be reset to the
factory settings using the key buttons
x x
"Up" and
JOB has been reset
1 x
Machine returns to Display mode
1 x
Functional characteristics
Advanced functions on the welding machine control
"Up" and "Down" (left)
"Down" (right)
Display
Program steps
Special-Mode
Block Job
"Up"
Block Job
"Up" and
Block Job
No change
Last parameters
selected are
displayed
Display
Job Manager
Res. Job: xxx
Res. Job: xxx
Res. Job: xxx
0
1
0
87