Sensor (Waste Toner Contact) Removal - Lexmark CS720 Service Manual

7
Release the two tabs (C) from the mounting assembly, and then remove the sensor.

Sensor (waste toner contact) removal

1
Remove the waste toner bottle.
2
Remove the motor cover. See
3
Remove the sensor (paper size). See
4
Disconnect the waste toner bottle contact cable (A) from the controller board.
5
Route the cable through the printer, and then remove the sensor contact assembly.
"Motor cover removal" on page
"Sensor (paper size) removal" on page
Repair information
314
273.
312.
5028