Hopping Shaft Assembly - Oki OKIFAX4550 Maintenance Manual

4.3.16 Hopping Shaft Assembly

(1) Disassembly procedure
a) First, carry out procedure up to the point
of the 4.3.2 (ID Unit, Cover-Rear and
Cover-MAIN).
b) Dismount the high-voltage power sup-
ply board. (See Section 4.3.9)
c) Dismount the paper holder assembly.
(See Section 4.3.10)
d) Dismount the sheet guide.
(See Section 4.3.11)
e) Dismount the side plate M.
(See Section 4.3.11)
f) Raise up roller holder, slide hopping
shaft assembly, and dismount roller
holder and hopping roller. (Knock pin
also comes off at the same time. Take
care not to lose it.)
g) Draw out hopping shaft assembly to the
right and dismount magnet H.
(2) Reassembly procedure
Reverse the disassembly procedures
41309401TH Rev.4
Magnet H
Roller holder
Hopping roller
Knock pin
Hopping shaft
assembly
175 /