Configuring Radius Accounting Parameters; Figure 3-90: Radius Parameters - AudioCodes MediaPack MP-124 User Manual

Mediapack mp-11 series cpe & access analog gateways
Hide thumbs Also See for MediaPack MP-124:
Table of Contents

Advertisement

Parameter
MWI Suffix Pattern
[MWISuffixCode]
MWI Source Number
[MWISourceNumber]
SMDI
Enable SMDI
[SMDI]
SMDI Timeout
[SMDITimeOut]
3.4.5.2

Configuring RADIUS Accounting Parameters

The 'RADIUS Parameters' page is used for configuring the Remote Authentication Dial In
User Service (RADIUS) accounting parameters.
To configure the RADIUS parameters, take these 4 steps:
Open the 'RADIUS Parameters' page (Configuration tab > Advanced Applications
1.
menu > RADIUS Parameters page item).
Configure the RADIUS accounting parameters according to the table below.
2.
Click the Submit button to save your changes.
3.
To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.
4.
SIP User's Manual
Determines the digit code used by the device as a suffix for 'MWI
On Digit Pattern' and 'MWI Off Digit Pattern'. This suffix is added to
the generated DTMF string after the extension number.
The valid range is a 25-character string.
Determines the calling party's phone number used in the Q.931
MWI SETUP message to PSTN. If not configured, the channel's
phone number is used as the calling number.
Enables Simplified Message Desk Interface (SMDI) interface on
the device.
[0] Disable = Normal serial (default).
[1] Enable (Bellcore)
[2] Ericsson MD-110
[3] NEC (ICS)
Note: When the RS-232 connection is used for SMDI messages
(Serial SMDI), it cannot be used for other applications, for example,
to access the Command Line Interface (CLI).
Determines the time (in msec) that the device waits for an SMDI
Call Status message before or after a SETUP message is
received. This parameter synchronizes the SMDI and analog CAS
interfaces.
If the timeout expires and only an SMDI message is received, the
SMDI message is dropped. If the timeout expires and only a
SETUP message is received, the call is established.
The valid range is 0 to 10000 (i.e., 10 seconds). The default value
is 2000.
Figure 3-90: RADIUS Parameters Page
194
MediaPack Series
Description
Document #: LTRT-65411

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents