Huawei OceanStor S2600 Command Reference Manual page 207

OceanStor S2600 Storage System
Command Reference
Format
chgtimehyimg -si session ID [-n maximum numbers] [-ti time interval] [-i source LUN ID] [-
st start time]
Parameters
Keyword and Value Description
-si session ID
-n maximum numbers The HyperImage number. The value ranges from 1
-ti time interval
-i source LUN ID
-st start time
Modes
Normal mode.
Level
Super administrator level and administrator level.
Usage Guidelines
l
l
l
Example
Change the time interval of creating the HyperImage for the session with the ID of 1 to 40
minutes.
Issue 07 (2010-05-20)
The section ID. The value ranges from 0 to 7.
to 8.
The time interval. The value ranges from 30 to
43200. The unit is minute (min).
The source LUN ID.The format is id0, id1... You
can enter up to eight source LUN IDs at a time. The
value ranges from 0 to 511.
The start time. The format is YYYY-MM-DD/
hh:mm:ss.
The start time must be later than the current time
shown on the device.
The chgtimehyimg command modifies the information on a timing HyperImage. The
information includes the source LUN ID, the number of the HyperImages to be created,
the time interval, and start time.
This command is available only when the HyperImage is stopped. After being modified,
the timing HyperImage task resumes, and the data in the original HyperImage is updated.
The time to activate the timing HyperImage must be later than the current time shown on
the device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Value-Added Service Management Commands
Default Value
None.
None.
None.
None.
None.
9-23