Eth Switch Qos Config - Technicolor TG582n Cli Reference Manual

ETH COMMANDS

eth switch qos config

Configure common qos parameters.
SYNTAX:
eth switch qos config
where:
state
nbrOfQueues
realtime
threshold
rxbackpressure
txbackpressure
404
state = <{enabled|disabled}>
[nbrOfQueues = <number{0-4}>]
[realtime = <{enabled|disabled}>]
[threshold = <number{0-15}>]
[rxbackpressure = <{disabled|enabled}>]
[txbackpressure = <{disabled|enabled}>]
Enable/disable QoS.
Number of queues.
Enable/disable realtime.
Tx Qos threshold.
Enable/disable controlled receive from switch (OBC pauses
Rx).
Enable/disable controlled transmit to switch (switch pauses
Tx).
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL