ETH COMMANDS
eth filter operand config
Set the operand to a certain type (will reset content first).
SYNTAX:
eth filter operand config
where:
operand
type
operator
protocollevel
length
mask
value
daclass
frameclass
ipprotocol
action
offset
366
operand = <{}>
type = <{CheckDAClass|CheckFrameClass|
CheckVLANPriority|CheckVID|CheckIPProto|
CheckSize|Match|Modify|CheckCheckSum|
UpdateCheckSum}>
operator = <{Equal|Less|LessEqual|InSet}>
protocollevel = <{EthernetFrame|Protocol|
EthernetPayload|ULPHeader|ULPPayload}>
length = <number>
mask = <string>
value = <string>
daclass = <{Unicast|Multicast|Broadcast}>
[frameclass = <{Eth2|SNAPEType|SNAP8021H|
SNAPOther|LLCNLPID|LLCOther}>]
[ipprotocol = <number{0-254}>]
action = <{Delete|Insert|Modify}>
offset = <number>
[priority = <number{0-7}>]
size = <number>
[vid = <number{1-4095}>]
protocol = <{IP|UpperLayer}>
The name of an operand.
The type to set.
The compare operator.
The protocol level from where to start offset/size
calculations.
The length of the compare value/mask combination in
bytes..
The mask to be used on the value.
The value.
The destination address class.
The Ethernet frame class to filter on.
The IP protocol to filter on.
The action to undertake with matching filter..
At which offset from protocol level in bytes the Match/
Modify action should start (in bytes).
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
REQUIRED
REQUIRED
REQUIRED
REQUIRED
REQUIRED
REQUIRED
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
REQUIRED
REQUIRED