Igmp Proxy Config - Technicolor TG582n Cli Reference Manual

IGMP COMMANDS

igmp proxy config

Configure the IGMP proxy.
SYNTAX:
igmp proxy config
where:
state
qi
qri
lmqi
rv
advinter
initadvinter
initadvcount
requirera
localgroup
496
[state = <{disabled|enabled}>]
[qi = <number{1-31744}>]
[qri = <number{1-3175}>]
[lmqi = <number{1-3175}>]
[rv = <number{2-7}>]
[advinter = <number{4-180}>]
[initadvinter = <number{1-4}>]
[initadvcount = <number{1-10}>]
[requirera = <{disabled|enabled}>]
[localgroup = <{disabled|enabled}>]
Enable/Disable the IGMP proxy.
The interval in seconds between general queries sent by the
querier.
The maximum response time in seconds for an IGMP client
in reply to general queries.
The maximum response time in seconds for an IGMP client
in reply to group specific queries.
The robustness variable allows tuning for expected IGMP
packet loss.
The interval in seconds for unsolicited MRD advertisements
(see rfc4286).
The interval in seconds for initial unsolicited MRD
advertisements (see rfc4286).
The maximum number of initial unsolicited MRD
advertisements (see rfc4286).
Enable/Disable the router alert IP option check.
Enable/Disable the processing of a local multicast group in
an IGMP packet.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL