eth switch shaper ifconfig
Configure per port shaper parameters.
SYNTAX:
eth switch shaper ifconfig
where:
port
ingress
shaper
state
speed
burstsize
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
port = <number{1-4}>
ingress = <{enabled|disabled}>
shaper = <number{0-1}>
[state = <{enabled|disabled}>]
[speed = <number{64000-1000000000}>]
[burstsize = <{16|20|28|40|76|140|268|500}>]
The port.
Ingress port = enabled; egress port = disabled.
The shaper instance.
Enable/disable shaping.
Speed in bits/sec.
Burst size in KBytes.
ETH COMMANDS
REQUIRED
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
409