NAT COMMANDS
nat tmpladd
Add an address mapping template.
SYNTAX:
nat tmpladd
where:
intf
group
timeout
type
outside_addr
inside_addr
access_list
foreign_addr
protocol
outside_port
inside_port
mode
weight
status
654
[intf = <{loop|Internet|LocalNetwork}>]
[group = <{wan|local|lan|tunnel|dmz|guest} or
number>]
[timeout = <number{0-65535}>]
[type = <{napt|nat}>]
outside_addr = <ip-range>
[inside_addr = <ip-range>]
[access_list = <ip-range>]
[foreign_addr = <ip-range>]
[protocol = <{ah|egp|esp|ggp|gre|hmp|icmp|
igmp|pup|rdp|rsvp|tcp|udp|vines|xns-idp|6to4|
ipip} or number>]
[outside_port = <port-range>]
[inside_port = <port-range>]
[mode = <{auto|inbound|outbound}>]
[weight = <number{0-255}>]
[status = <{up|down}>]
The IP interface name scope for this template.
The IP interface group scope for this template.
Lifetime (seconds) for this template.
The type of template.
The outside (typically public) IP address or index (range for
NAT).
The inside (typically private) IP address or index (range for
NAT).
The range of inside addresses the template is restricted to.
The range of destination addresses the template is restricted
to.
The IP protocol.
The outside port number or range (only for NAPT).
The inside port number or range (only for NAPT).
The mode to create the portmap.
The weight to be used for the template instance(s).
The administrative state of template.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL