Eth Bridge Ifconfig - Technicolor TG582n Cli Reference Manual

ETH COMMANDS

eth bridge ifconfig

Modify a bridge interface configuration.
SYNTAX:
eth bridge ifconfig
where:
brname
intf
dest
portstate
retry
priotag
vlan
prioconfig
ipprec
priority
regenprio
ingressfiltering
326
[brname = <{bridge}>]
intf = <{OBC|ethport1|ethport2|ethport3|
ethport4|WLAN|virt}>
[dest = <{}>]
[portstate = <{disabled|learning|forwarding}>]
[retry = <number{0-65535}>]
[priotag = <{disabled|enabled}>]
[vlan = <{default}>]
[prioconfig = <{disabled|overwrite|increase}>]
[ipprec = <{disabled|precedence|dscp}>]
[priority = <number{0-7}>]
[regenprio = <string>]
[ingressfiltering = <{disabled|enabled}>]
[acceptvlanonly = <{disabled|enabled}>]
[mcastfilter = <{disabled|enabled}>]
[dynvlan = <{disabled|enabled|switched}>]
[wan = <{disabled|enabled}>]
[igmpsnooping = <{disabled|enabled}>]
[priotransparent = <{disabled|enabled}>]
[bpdufiltering = <{disabled|enabled}>]
[xtratagging = <{none|c-vlan|s-vlan}>]
The name of a bridge instance.
The name of the bridge interface to configure.
The destination for this interface. Typically an ATM or a
physical interface name.
The bridge portstate for this interface.
The number of WAN connection setup retries before giving
up.
Enable/Disable priority tagging.
The default VLAN.
The priority configuration for this interface.
The IP precedence for this interface.
The default priority for untagged ingress packets.
The priority regeneration table for tagged ingress packets.
Enable/disable discard of tagged ingress packets if the
interface is not part of the VLAN.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
OPTIONAL
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL