Ip Debug Sendto - Technicolor TG582n Cli Reference Manual

IP COMMANDS

ip debug sendto

Send UDP packets.
SYNTAX:
ip debug sendto
where:
addr
count
size
interval
listen
dffield
srcaddr
srcport
dstport
dstintf
520
addr = <ip-address>
[count = <number{1-1000000}>]
[size = <number{0-20000}>]
[interval = <number{1-1000000}>]
[listen = <{disabled|enabled}>]
[dffield = <{disabled|enabled}>]
[srcaddr = <ip-address>]
[srcport = <number{1-65535}>]
dstport = <number{1-65535}>
[dstintf = <{loop|Internet|LocalNetwork}>]
The destination IP address.
The number of datagrams to send.
The size of the datagram.
The interval in milliseconds between datagrams.
Don't send, just listen for incoming datagrams.
Enables setting of the don't fragment flag in the IP headers
of the ping packet(s).
The IP source address to use.
The UDP source port number to use.
The UDP destination port number to send to.
The IP interface name.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
DMS-CTC-20101206-0049 v1.0.Copyright 2011Technicolor. All rights reserved.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
REQUIRED
OPTIONAL