Static Ipv4 Source Guard Configuration Example - HP 5920 Series Configuration Manual

Task
Display IPv4 binding
entries.
Clear IPv4 biding entries.
For IPv6 source guard:
Task
Display static IPv6 binding
entries.
Clear IPv6 biding entries.

Static IPv4 source guard configuration example

Network requirements
As shown in
connected to Ten-GigabitEthernet 1/0/1 of Switch B. Host C is connected to port Ten-GigabitEthernet
1/0/2 of Switch A. Switch B is connected to port Ten-GigabitEthernet 1/0/1 of Switch A. All hosts use
static IP addresses.
Configure static IPv4 source guard entries on Switch A and Switch B to meet the following requirements:
On port Ten-GigabitEthernet 1/0/2 of Switch A, only IP packets from Host C can pass.
•
• On port Ten-GigabitEthernet 1/0/1 of Switch A, only IP packets from Host A can pass.
On port Ten-GigabitEthernet 1/0/2 of Switch B, only IP packets from Host A can pass.
•
On port Ten-GigabitEthernet 1/0/1 of Switch B, only IP packets from Host B can pass.
•
Figure 64 Network diagram
Configuration procedure
Configure Switch A:
1.
# Configure IP addresses for the interfaces. (Details not shown.)
Command
display ip source binding [ static | [ vpn-instance vpn-instance-name ]
[ dhcp-relay | dhcp-server | dhcp-snooping ] ] [ ip-address ip-address ]
[ mac-address mac-address ] [ vlan vlan-id ] [ interface interface-type
interface-number ] [ slot slot-number ]
reset ip source binding [ static [ ip-address ip-address ] | [ vpn-instance
vpn-instance-name ] [ { dhcp-relay | dhcp-server | dhcp-snooping } [ ip-address
ip-address ] ] ]
Command
display ipv6 source binding static [ ip-address ipv6-address ] [ mac-address
mac-address ] [ vlan vlan-id ] [ interface interface-type interface-number ] [ slot
slot-number ]
reset ipv6 source binding [ static [ ip-address ipv6-address ] ]
Figure 64, Host A is connected to port Ten-GigabitEthernet 1/0/2 of Switch B. Host B is
195