Setting Other Lldp Parameters - HP A3100-8 v2 SI Configuration Manual

Follow these steps to configure a management address to be advertised and its encoding format on one
or a group of ports:
To do...
Enter system view
Enter
Ethernet
interface
view or port
group view
Allow LLDP to advertise the
management address in LLDPDUs and
configure the advertised management
address
Configure the encoding format of the
management address as character
string

Setting other LLDP parameters

The Time To Live TLV carried in an LLDPDU determines how long the device information carried in the
LLDPDU can be saved on a recipient device.
By setting the TTL multiplier, you can configure the TTL of locally sent LLDPDUs, which determines how
long information about the local device can be saved on a neighbor device. The TTL is expressed using
the following formula:
TTL = Min (65535, (TTL multiplier × LLDPDU transmit interval))
As the expression shows, the TTL can be up to 65535 seconds. TTLs greater than 65535 will be rounded
down to 65535 seconds.
Follow these steps to change the TTL multiplier:
To do...
Enter system view
Set the TTL multiplier
Set the LLDPDU transmit interval
Set LLDPDU transmit delay
Use the command...
system-view
Enter Layer 2
interface interface-type
Ethernet interface
interface-number
view
port-group manual
Enter port group view
port-group-name
lldp management-address-tlv
[ ip-address ]
lldp
management-address-format
string
Use the command...
system-view
lldp hold-multiplier value
lldp timer tx-interval interval
lldp timer tx-delay delay
173
Remarks
—
Required
Use either command.
Optional
By default, the management
address is sent through LLDPDUs.
For a Layer 2 Ethernet port, the
management address is the main IP
address of the lowest-ID VLAN
carried on the port. If none of the
carried VLANs is assigned an IP
address, no management address
will be advertised.
Optional
By default, the management
address is encapsulated in the
numeric format.
Remarks
—
Optional
4 by default.
Optional
30 seconds by default
Optional
2 seconds by default