Instrument Panel - New Holland Boomer 45 Operator's Manual

Instrument panel

1. Park Brake Indicator Light - Illuminates if the park brake is engaged with the key switch rotated from the "OFF"
position.
2. Flasher Turn Lights - Operate when the multifunction switch lever is moved downwards for left turns the left arrow
will flash. The key switch has to be in the "ON" or "START" positions.
3. Flasher Warning Lights - Operate when the operator places the multifunction switch in the hazard or road lights
position, regardless of the key switch position. Use the flasher warning lights, road lights when traveling on public
roads, day or night.
4. Tachometer - Registers engine Revolutions Per Minute (RPM). The gauge is marked in increments of 100 and
will return to zero when the engine is not running.
5. PTO Speed Indicator - Determined by the position of the needle on the tachometer. The tachometer is marked
to indicate 540 RPM of PTO. If the needle registers above the 540 RPM mark, this indicates a dangerous over
speed condition, reduce the engine (RPM) immediately.
6. Flasher Turn Lights - Operate when the multifunction switch lever is moved upwards for right turns the right arrow
will flash. The key switch has to be in the "ON" or "START" positions.
7. Fuel Filter Warning Indicator Light - Illuminates when there is water in the fuel filter. When this indicator illuminates
the engine will shut off automatically. Service of the fuel filter will be required.
8. Engine Warning Indicator Light - Will illuminate when there is a fault detected in the engine control system. This
indicator light will be illuminate, either continuously or blinking, depending on engine fault. See 3-19 for a detailed
explanation of engine warning indicator light operation.
9. Low fuel level warning indicator - When the fuel in the fuel tank is under minimum level, this indicator shall be ON.
NOTICE: If this indicator turns on, fill the fuel tank immediately with fuel.
10. Battery Charge Warning Light - Illuminates when the key switch is in the "ON" position and goes out when the
operator starts thee engine. An illuminated bulb during this operation indicates the charging system is not oper-
ating normally.
11. Engine Oil Pressure Warning Light - Illuminates with the key switch in the "ON" position and remains illuminated
for a short period, after you start the engine. The light indicates low engine oil pressure only and goes out when
3 - CONTROLS AND INSTRUMENTS
NHIL20CT00089FA
3-14
1