Remote Control Levers And Quick Couplers - Cab (If Equipped) - New Holland Workmaster 25S Operator's Manual

Remote control levers and Quick couplers - Cab (If equipped)

CAUTION
Escaping fluid!
Hydraulic fluid or diesel fuel leaking under pressure can penetrate the skin and cause infection or
other injury. To prevent personal injury: Relieve all pressure before disconnecting fluid lines or per-
forming work on the hydraulic system. Before applying pressure, make sure all connections are tight
and all components are in good condition. Never use your hand to check for suspected leaks under
pressure. Use a piece of cardboard or wood for this purpose. If injured by leaking fluid, see your
doctor immediately.
Failure to comply could result in minor or moderate injury.
WARNING
Avoid injury!
When welding, always wear proper protective equipment and welding clothing. All persons in the
work area must, at minimum, wear welding goggles. Never look directly at the welding arc without
welding eye protection.
Failure to comply could result in death or serious injury.
WARNING
Escaping fluid!
Do not connect or disconnect hydraulic quick coupler under pressurized conditions. Make sure all
hydraulic pressure is removed from the system before connecting or disconnecting hydraulic quick
coupler.
Failure to comply could result in death or serious injury.
• The remote control levers are used to operate the hydraulic cylinder(s) and/or motor(s) of the implement attached
to the tractor.
• If you move the remote control lever(s) backward, the hydraulic pressure works to the upper coupler(s) of the related
lever(s), and the lower coupler(s) is connected to the hydraulic return line.
• Each lever of the parallel circuit remote control valve can be operated independently , and when operating the
levers at the same time, the line that is under less pressure begins to work first.
• After connecting and cycling the hydraulic equipment, check the transmission oil level of the tractor.
• When releasing the lever(s) after operating fully, the lever(s) will return to the neutral position automatically.
ID
1 Lever 1
Lever 2 (optional)
2
A Forward
B Backward
3 - CONTROLS AND INSTRUMENTS
Description
3-26
C0104A
W1178A
W0095B
1
NHIL20CT01101AA