Connecting Rods - New Holland 6010 Service Manual

Maximum crankshaft flange run‐out with gauge, over 108 mm
(4.25") diameter (total gauge reading)
Maximum flywheel seat eccentricity relative to main journals (total
gauge reading)

Connecting rods

Small end bore diameter
Small end bushing outer diameter
Bushing interference fit in small end
Small end bushing fitted I.D .
Big end bore diameter
Maximum connecting rod axis misalignment at 125 mm
Maximum connecting rod weight difference over a complete set
from the same engine
Pistons
Piston diameter: measured at 12 mm from base of skirt and right
angles to pin
Piston clearance in liner
max. wear clearance
Piston oversize range
Piston stand‐out with respect to head at T.D.C
Piston pin diameter
Piston pin seat bore in piston
Piston pin clearance in piston
Piston pin clearance in small end bushing
maximum wear clearance
Maximum weight difference between pistons on same engine
Piston ring clearance in groove
• Top
• 2nd
• 3rd
Maximum wear clearance
• Top
• 2nd and 3rd .
Piston ring gap
• Top
• 2nd
• 3rd
Maximum wear gap
Valve gear
Valve timing gears
Timing gear backlash
Idler gear jack shaft diameter
Idler gear bushing fitted I.D. after reaming
Jack shaft journal clearance in bushing
Max. wear clearance
Bushing interference fit in idler gear
Lift and power steering pump drive gear shaft
Diameter
Bushing fitted I.D. after reaming
Shaft clearance in bushing
Bushing interference fit in housing
Pump drive gear thrust washer thickness
Engine - Engine and crankcase
47969433 28/11/2016
10.1 [10.001] / 5
0.025 mm
0.04 mm
41.846 - 41.884 mm
41.979 - 42.017 mm
0.095 - 0.171 mm
38.004 - 38.014 mm
67.407 - 67.422 mm
± 0.07 mm
25 g
103.852 - 103.870 mm
0.130 - 0.172 mm
0.30 mm
0.6 mm
0.430 - 0.840 mm
37.983 - 37.99 mm
38.000 - 38.006 mm
0.010 - 0.023 mm
0.014 - 0.031 mm
0.06 mm
20 g
0.090 - 0.122 mm
0.060 - 0.092 mm
0.040 - 0.080 mm
0.50 mm
0.20 mm
0.30 - 0.45 mm
0.60 - 0.85 mm
0.30 - 0.55 mm
1.20 mm
0.160 mm
36.975 - 37.000 mm
37.050 - 37.075 mm
0.050 - 0.100 mm
0.15 mm
0.063 - 0.140 mm
36.975 - 37.000 mm
37.050 - 37.075 mm
0.050 - 0.100 mm
0.063 - 0.140 mm
1.45 - 1.50 mm